Questions & Answers for: key barrel Vehicle Parts & Accessories

...normally a spring loaded pin holds barrel in socket Tip of key has broken off in ignition barrel of 1994 Land Rover Discovery. How do I get it out or how do I change the whole ignition barrel. ...

...barrel, then gently turn key 90 degrees, and offer into barrel housing, ensure the secure pin is at all time still into the barrel, slide the barrel into houseing slowly until you mate up the barrel ...

...barrel and key by removing steering column covers turn ignition to on position and with small shank screw driver push in hole in outer top rear section of barrel assembly then pull out ignition lock ...

...key barrel ??? The key needs to be inserted into the switch assy and turned to (usually) the first key position, there will be a small hole in the barrel assy in order to press a locating pin (check ...

key code in barrel Lost car keys need key code from barrel to get new key cut. not sure how to remove barrel. You will need to drill the guts out of the key cylinder to remove it without a working key

...Hi Most ign barrels You need to put the key in barrel turn to position 1 & pull out barrel But looking at your vid looks like the barrel has been damaged Does your key still fit in the

...barrel and key from a breakers and have read roughly how to replace it,the trouble i have is my replacement barrel has no wiring so i assme i have to transfer my wiring block from the old to the ...

...barrel/key are so worn they are'nt engaging properly when turning off put a slight downwards pressure as turning key this may engage the key and barrel but sounds like need a new key if thats worn ...

...key, get the barrel rep Looked to see if there was a lock barrel serial number on the face of the barrel but unfortunately there is no number s amped on the barrel. -Go to key master, they'll cut a ...

...key barrel from a boot lock on a VW Fox 58 plate Remove the boot lid interior trim panel to access the lock assembly. Locate the retaining clip that holds the key barrel in place. The clip is ...