...kenwood mixer prospero KM265. The only problem I have is getting the Proccessor to go. Could you advise me please! Hello. Here is a link to the owner manual ...
Question about Prospero Compact Km265 4.3 Litre Stand Mixer
The machine keeps cutting out during blending and mixing need clarification. what does cut out mean? The motor stops altogether? The beaters stop spinning but you still get motor sounds? It comes on ...
Question about Prospero Compact Km265 4.3 Litre Stand Mixer
...Kenwood Prospero.look for 2 pairs of watty (1.1 kohm 2W?)series resistors. At junction of the 2 pairs there is glue which degrades with heat and becomes conductive. CAREFULLY scrape away the old glue ...
kenwood prospero km262 stopped working It just won't turn on In my case, capacitor C1: 470nF (on the circuit board) proved to be the cause. It measured only half its normal value. It's part of a ...
Question about Prospero Compact Km265 4.3 Litre Stand Mixer
Kenwood mixer not going back together Taken apart to clean, now can not get back together properly to screw lid back on, please can I have advise on who could put it back together for me. Hi, If you ...
Question about Prospero Compact Km265 4.3 Litre Stand Mixer
service manue for Kenwood Major about 15 years old my Kenwood Major is about 15 years old, and has just stopped working. It was working last night, then this morning wont switch on are there any ...
Question about Prospero Compact Km265 4.3 Litre Stand Mixer
...kenwood prospero starts at high speed when turned to speed 1 & cuts out at speed 2 I've replaced the potentiometer unit with a new one but no joy Your control board is probably going out. Will ...
kenwood prospero wont start use to work no problem, but recently when i attach the processor it doesn't work even with everything clicked into place and now not even the main mixer works. Seems to be ...
Question about Prospero Compact Km265 4.3 Litre Stand Mixer
...Kenwood Prospero stand mixer km24? I own a two year old prospero. It has a fault where it will work once and then not turn on again. I've taken the cover off and I can see that the PCB is showing ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions