Jura Capress Impressa E8 My machines drawer won't go back in place. Any ideas? Open the drawer and take out the box for the grounds. Run a rinse cycle and it should now go back into place. shut down ...
...vinager like most will recommend, then just pour diluted vinager. Put no more than one to one ratio into the machine like you would water for coffee and let it process just like when you make
Question about Impressa E9 Espresso Machine & Coffee Maker
...coffee came out. Now something inside is preventing pushing the drawer in Take out the used grounds container, and put the drawer back in the machine. After the machine has finished positioning, then ...
machine stuck and can't put drawer back in. i may have opened the draw during the shut off process If the drawer is stuck and cannot be put back in then put everything back except for the coffee grind
Question about Impressa E8 Espresso/Coffee Maker
Jura E8 in order for the "missing drawer" light to go off. I've unplugged the unit to allow chip to reset... nothing. I think the elevator is stuck thus causing the drawer to not go in place
...drawer cannot be put into the machine ? If so check that the grounds holder rubber flat is seated correctly on it. If it is not the tray cannot push home fully. --- Please dont forget to vote this ...
...make any coffee. I had the same issue. Had to send it to Jura to be repaired. Cost $235.00 and they cleaned it and sent it back. I was not able to fix it myself. They said there was a major
Question about Impressa E9 Espresso Machine & Coffee Maker
jura capresso e9 water not coming through spout when machine is turned on. no water comes out of spout, it leaks into the drawer Use a pin or a needle on the spout to clean the nozzle head. Most of ...
Question about Impressa E8 Espresso/Coffee Maker
...machine appears to be in middle of an action. But we can't reset. For Jura F7 Series, "Tray Missing, can't put it back in". With a small flashlight, look in to the cavity which the tray ...
Question about Impressa E8 Espresso/Coffee Maker
...coffee machine is built in and not your brand but our problem related to a sensor at the back of our tray which had broken off we found it and glued it back on which worked for a little while in the ...
Usually answered in minutes!
1,392 Questions
801 Questions
725 Questions
572 Questions
453 Questions