Questions & Answers for: jumpers sata Computers & Internet

...SATA II drives do have jumpers to make them backwards compatible with 1.5 Gb/s (SATA II drives are 3.0 Gb/s). So if your system is older and can only handle SATA (first Gen) then you have to add a ...

...drive order is determined by what SATA port they are plugged into, or by the BIOS configuration. slave drives typically have no jumpers at all and master drives have a jumper vertically on pins 1 and ...

Epox motherboard and SATA disk I have Epox KT400A and it does not see sata II disks. I put jumper on HDD to switch it in sata I mode and MB doesn't detected it. Disk is WD1600AAJS. It was same with ...

i can detect no SATA' HDD The ECS PM800-M2 only supports SATA 1.0 hard drives. If you are using a newer SATA 3.0 hard drive, there is a jumper on the hard drive which has to be set to SATA 1.0 in ...

...SATA Drives do not need jumpers to set primary and secondary drive positions. Each sata drive gets it's own connection to the motherboard. Check you motherboard diagram, and make sure the 320GB drive ...

im just about to buy a SATA II 500GB hard disk for this MB, i need to know if this would be compatible with the MB??! Thanks SATA 2 (SATA 300) is not backwards compatible with a SATA (SATA 150) ...

jumpers are for slave Western Digital WD Caviar Blue WD3200AAJS - hard drive - 320 GB - SATA-300 SATA SATA drives don't need jumpers. Just install the drive and the computer will assign a drive letter

my sata hard drive and do I need a jumper on sata hard drive and what setting would the jumper go on A sata drive doesn't need jumpers. The jumpers were only required when 2 drives used the same cable

sata cable & pata cable have a any jumper setting Hi, The hard drive / optical drive have jumper settings, not the motherboard. PATA has jumper settings, but SATA do not require any. The diagram ...

western digital wd2500bevt slave jumper settings Which jumper setting is for slave SATA drive position is determined by the plug on the motherboard, not a jumper. Jumper settings are for PATA drives ...