Questions & Answers for: HP Pavilion jumper setup

...jumper on pins 2-3. Plug-in the computer to the power source and power on the computer. The computer starts the Setup program and the Maintenance menu is displayed. Select Clear Passwords and press ...

...the first drive's jumper setting is at Master and not CS(cable select). Reboot and enter into BIOS setup and check to see that both the drives are detected. Hope this will help you. thank u for ...

...jumper / dipswitch the label of that switch can be anything; however, in most cases will be labeled CLEAR - CLEAR CMOS - CLR - CLRPWD - PASSWD - PASSWORD - PWD. On the computer motherboard locate and ...

...Temporarily set jumper CLR_CMOS to pins 1-2. Wait 5-10 seconds and then return the jumper to pins 2-3. When you start the system you will need to enter BIOS setup to reset any custom BIOS

...jumper setting is set as "Master" The manual should explain this. Most drives are set to this by default. Before windows boots Press either F8, F7 or F12. This should get you to the BIOS screen of ...

...setup will be forgotten by the BIOS. Most motherboards have a set of shorting pins very near that battery that you can put a jumper on for a few seconds and that will short the battery to ground, ...

...setup, date/ time etc. Another way to clear CMOS is, reset the CMOS Jumper in motherboard. To detect your hard drive you can try to check by change the hard drive cables. Change the port in ...

...setup, you hit the <del> or <F10> key on start up.If you want to reset password protection on CMOS, you have to Follow the jumper instructions ...

...jumper to pins 2-3. When you startup the PC you will need to enter BIOS setup to reset any custom BIOS settings. Clearing the BIOS password The BIOS password is used to protect BIOS settings from ...

...setup This depends on the hard drives. Each drive has different ways to set master/slave. It's usually written on the drive, if not, you can find the setting with a google search, just search the ...