Questions & Answers for: HP jumper setup

jumper was (pin 1-2 or 2-3). Power on the computer, enter bios (Setup), F10 or F2 (I don't recall if they changed the key) Disable 'Power On Password' Switch off PC and replace the jumper. where can i

...selection set to slave, after checked your hardrive jumper if it is set to slave change to master, hope you know how to change the jumper setup.. hope it will help.. tnx, if theres a question pm

smsc motherboard jumpers setting(compaq presario 5000 smsc motherboard jumpers setting no need jumpers, the smsc are being setup in the BIOS, enable it or disabled... go to BIOS Setup

setup as it is asking for a password. I have tried removing the CMOS battery but nothing works. Where exactly is the jumper located. People keep talking about hardware reset by moving the jumper but i

setup. Typically a jumper will be found across pins #1 and #2 as the default position, and by shutting the computer down, unplugging the power cord and then moving the jumper so that it is across pins

jumper back to the 1-2 position. Replace the side-panel. Reconnect the AC power. Restart, and enter BIOS SETUP. Use 'LOAD BIOS DEFAULTS'. Done. nothing worked but i tryed this but it was two pins next

...jumper on both pins, then repeat steps 6 through 8. Establish the new passwords in Computer Setup. To establish new passwords on the HP xw8200 Workstation and HP xw6200 Workstation, repeat steps 1 ...

...jumper to pins 2-3. When you startup the PC you will need to enter BIOS setup to reset any custom BIOS settings. Clearing the BIOS password The BIOS password is used to protect BIOS settings from ...

...setup button and press "enter" 3 times it opens up and later no changes take place. been waiting for a solution for a very very long time. by the way i am seshadri. hope to find a solution to my ...

...the password features. To establish new passwords, repeat steps 1 through 4, replace the password jumper on pins 1 and 2, then repeat steps 6 through 8. Establish the new passwords in Computer