...jumper to its original setting then try to switch on your pc it will reset the original settings of your mainboard. Fiend your solution direct from mercury. Here is your solution..... ...
MOTHER BOARD DOES NOT WORK!! NO LIVE VIDEO SCREEN!! check jumper settings. im sure that its there.
...detects them as 333Mhz. How do I make my computer to recognize them as 400MHz. I know there is a jumper setting I need to change....but I lost my manual, hence do not know which jumper to change. ...
where is the jumper pins loacted in mercury board pvm4 Click on the link below to download the manual Refer the manual for the motherboard layout diagram and the jumper setting detail.
settings to accept that processor if u dont then it will burn up the motherboard and processor Consult with your motherboard website for the model of your motherboard to see if the P4 you are going to
...settings of the motherboard Thx During the boot process you will see on the screen to press a certain key to enter setup Press and hold that key during the boot up process to enter BIOS the scroll ...
...diagram on plugs which go into wiper motor in order to test power from switch etc. circuit breaker ok too? I think it 8.5 amp in fuse panel under dash. Next check the ground at the wiper motor, ...
...power on Hello download the manual here: http://www.mercury-pc.com/downloads_list.php?productid=515 Check all the jumper settings, and also the power supply. Maybe the mainboard is dead. Good ...
...jumper the fan motor to the battery ? First jumpering the fan motor to the battery is a bad idea. The fan will always run even if the vehicle is not running. The fan probably draws enough current to ...
...is totally drained. Tried to jump it and cables got too hot. hhheeellpppp Listen to me. Put the jumpers on the car, If you have a second set use them also. Go inside and have a cup of coffee and ...
Usually answered in minutes!
1,235 Questions
126 Questions
101 Questions
81 Questions