...bios settings. put away your coms cell for 15 minutes also u can reset your bios with jumper settings. then power up the pc. the jumper is near the cmos cell read that jumper instuction.on
...jumper settings, which I couldn't locate on the motherboard. Well this seems to be an issue with the CMOS battery. We may have to flush the bios settings and that will resolve the issue. Alfred B : ...
jumper) as was recommended, but i need to be able to locate that or any better solution to my being able to log on to my laptop. Hi, You can try this 1. Turn off the laptop 2. Disconnect AC adapter 3.
Question about Compaq Presario 6310US (DA201A#ABA) PC Desktop
smsc motherboard jumpers setting(compaq presario 5000 smsc motherboard jumpers setting no need jumpers, the smsc are being setup in the BIOS, enable it or disabled... go to BIOS Setup
Question about DVD1040i 20x Super Multiformat Dvd Writer, Internal Burner
...in computer i ave both in but only reconises 1 if you are using IDIE cable.set as try to see the jumper on the markings slave. if sata it will auto detect. If they are both connected to the same ...
jumper so that it is across pins #2 and #3 will clear the Bios/CMOS settings. Here's an example of a Supermicro PIIISEA motherboard. As you can see from the picture, we have added two small red arrows
...jumper settings. You can boot up your laptop with Tenorshare Data Recovery WinPE to recover your files.It allows users to burn ISO file to CD/DVD/USB Flash Drive and boot up Operating System from ...
...plug it in again and your BIOS password shall be removed. 2) You can also change your BIOS Jumper Setting. Generally the BIOS jumper resides on pin 1 and 2. You simple take it out and then ...
JUMPER SETTINGS Warning: Incorrect settings may produce undesirable results. Please research thoroughly before making any changes. You can set the jumper as follows: Clearing the BIOS settings CAUTION
...&slave You don't need to set master and slave in the bios. On IDE hard drives you make sure the jumpers on the hard drive are set to master and slave. It usually tells you which connectors the ...
Usually answered in minutes!
5,069 Questions
2,066 Questions
1,757 Questions
1,195 Questions
1,096 Questions