Question about Travelstar 80GN 60 GB Hard Drive
...jumper setting to make this a slave the drive doesn't show slave setting. This drive has a boot virus and can't repair with windows XP disk. When I scan drive the scan gets to 39% and then ends (Bad ...
...could be you computer isnt set up properly for the HD is this and internal HD or external?? your jumpers could be set wrong on the HD you just dont put a HD into a computer without setting the ...
...jumper setting explained please The usual jumper settings for a hard drive are: Cable Select Primary Secondary Cable select means that the mainboard will choose whether to make the drive primary or ...
Question about (DK23DA-20F) 20 GB Hard Drive
Slave jumper settings for a 2.5 Hitachi DK23DA-20F hard drive Hello, I'm installing a 2.5 Hitachi DK23DA-20F laptop drive in to a desktop as a slave drive and was wondering what the jumper settings ...
Question about Travelstar 5K100 HTS541080G9SA00 80GB 5400rpm 150MBps Serial ATA Serial ATA/150 I... (0A26924FT) Hard Drive
hi where is the jumper to put the hard drive into slave position on a hitachi TRAVELSTAR HTS541080G9SA00 ? I cannot find it Many thanks best regards Hi There are no jumpers to set on a SATA drive ...
Question about 80GB IDE Hitechi DeskStar 7K160 7200RPM 8MB HDS721680PLAT80 0Y30001 80 GB Parallel Hard Drive
hi just need the jumper settings to set this drive as master also do i need to connect it to the end of the cable? thanks Here is a list of the jumper settings: ...
Question about 250GB Hitachi 2.5" SATA Hard Disk Drive (5400rpm, 8MB cache) Hard Drive
...jumper setting to run my hitachi 250 gb sata laptop hdd as a slave ? There should be, look on the rear of the drive, close to the SATA and power connectors, you should see the jumper connections as ...
Question about Deskstar 7K1000B HDT721050SLA360 500GB 7200rpm SATA300 SATA Hard Drive
...f10 to save to cmos to restart you will have to have master with slave set up you can find the jumper location next to the power on a hard drive and the settings for plastic jumper location is ...
Question about Deskstar 7K1000B HDT721050SLA360 500GB 7200rpm SATA300 SATA Hard Drive
how do I set the jumpers to make it a slave? During the boot process you will see on the screen to press a certain key to enter setup Press and hold that key during the boot up process to enter BIOS ...
Question about Deskstar 7K1000B HDT721050SLA360 500GB 7200rpm SATA300 SATA Hard Drive
...jumper settings. If you have a SATA drive, there ARE no jumpers. If the drive is a PATA, then if it's connected with another drive or cdrom, then make the cdrom 'slave' and the disk ...
Usually answered in minutes!
89 Questions
55 Questions
43 Questions
33 Questions