...JL Audio amp spec? You need the old transistor. Knowing it's brown is not enough; you need to know its resistance value. It sounds like the resistor you replaced with has too low a resistance value, ...
jl audio 500/1 problem Low ohms lights on; Transistor Brown, replace it; low ohms light is off now and everything seems to work fine execpt when in low volume, it sounds good. When increase the gain, ...
...jl 1000/1 you have your amp wired at too low of an ohm load for the amplifier. This is why it is doing this. Jl amps are awesome and pretty much make everything idiot proof. Not calling you an idiot ...
...jl 500/1 the thermal light goes on and off every once in a while and the speakers stop playing you may have the ohm load to low and the amp is over heating or it need more air and ventilation. use a ...
...JL AUDIO 250/1 to a 500/1 and my problem is at higher volume,my amp goes out then after a few seconds it comes back on,could it be lack of power or bad grounding,cause I also have a JL 300/4 for my ...
...amp set up to the jl specs. Also I have wiredthe sub in a series and just does not sound like it is performing well and does not have good sound quality. It is BRAND NEW. What should I do? 1000/1v2 ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions