Questions & Answers for: jetta distributor

Ad

...jetta changed water pump car cranks but wont turn over i changed the water pump and my friend messed with the timing belt so i reset it and aligned all the proper alignments for the cams and pulleys ...

Ad

Question about 1999 Jetta

1 Answer

Jetta. Distributor 99 Jetta. Received code that distributor is going bad. Looked-up the distributor for my car. It shows the cap on it as one piece, however there appears to be a "coil pack" on top of

Ad

...jetta is running loud and is really loud when you put the gas on! it has a vibration at higher speeds. i replaced spark plugs distributor plus cap and rotor, and both oxygen sensors and that didnt ...

Jetta GLS. Where is it located it is located in the distributor and i suggest just replacing the whole distributor because there is a piece pressed on the top so you cannot access the sensor.I had the

Question about 2000 Jetta TDI

1 Answer

jetta 2000 glx vr6 when is raining the car stop Check your splash guards. Check your distributor and other components to be sure they are bolted tight with correct gaskets. The distributor, especially

...jetta. second time in a month that the car has cut off or not cranked in wet, damp weather The distributor maybe the problem if it has one. There is usually a rubber seall to keep moisture out. Maybe ...

Question about 1998 Jetta

1 Answer

...Jetta distributor cap firing order For the 1998 VW Jetta: I do not know if you have the 2.0L SOHC In-Line 4-Cylinder or the 2.8L DOHC V-6; however I have included both below. The 2.0L has a ture ...

...Jetta 3 electronics, especially when it comes to the coil as they give different stokes of spark to the distributor. Oil switch must have a pressure leak. Replace the switch as a small leak of ...

Question about 1992 Jetta

1 Answer

...jetta 2 1.8 motor. tdc are all in the right place.I am not sure the position of the distributor ? it does start but have dead spot when pulling of. With the #1 at TDC Compression, the distributor ...

Jetta I changed the distributor. if you didn't pull it out and only turned it there is either 2 marks or 2 metal rods that stick out the side that the bolt goes through the center did you take out the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23590 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6576 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...