We justed turned our apollo spa{galaxy} back on. Three blinking lights are flashing and the water is not heating up. The spa seems to have good preasure or is the preasure switch gone bad. please help
I just bought my hot tub, it shows ''FLO'' on the panel when i turn it on. I did every thing they say on the panflet but it still doesn`t work. Anything else i should do?? The problem is that the flow
I have a 300GAL Spa that was installed on a 120v 20amp two pole. I had a 240v 50amp breaker that I replced with two 120v 20amp breakers, we wired the tub and the pump works but when the heater is ...
...led stays on and 3 leds under the actual temperature read out blink on and off. Then if I turn the jets on, the pump runs fine and the 3 leds stop blinking and go off. I dis-connected the incoming ...
Question about Economy In - Ground Solar System
My Apollo hot tub stopped heating and the first set of jets are not working and both seemed to have gone out at the same time. The second set of jets and the air are fine. Does anyone have any ideas ...
Question about Economy In - Ground Solar System
...# 1125177. Every time I turn the thermostat up ... it trips the breaker. There is no heat. The jets still work, the pump still works, just no heat. We could not get the tub to regulate to 104.
Question about Economy In - Ground Solar System
Looking for a wiring diagram for an apollo spa model AP72R. with a thunderbolt control panel Model cm-101. Help appreciated Looking for a wiring diagram for an Apollo spa model AP72R. with a ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions