Questions & Answers for: Yamaha XJ 700 X Maxim jet

Question about 1985 XJ 700 X Maxim

1 Answer

1985 yamaha virago 700cc trouble keeping it running,battery ok,new gas,low on oil,could that be it as long as oil is not below the minimum mark your bike will run safetly .check plugs and fuel is ...

Ad

...any advice would be apreciated. It is in the carbs, A bike will act like that when it needs to be jetted, most jets are not adj, but whoever built the bike, must have messed with the carbs, you can ...

Ad

Question about 1985 XJ 700 X Maxim

1 Answer

...but when you try to get past that it just boggs down. Carbs have been cleaned. Spark plugs are jet black after a quick ride? Any help is appreciated. Hello, from your description, it sounds like ...

Question about 1985 XJ 700 X Maxim

1 Answer

...they are nice and clean. If your bowls were not flooded, then you may have a problem with the fuel jets. A lot of people take carburetors apart to clean them, and get the little brass jets in the ...

Question about 1985 XJ 700 X Maxim

1 Answer

...properly. If it's cold, I can't even jump start it. I replaced the needles and seat, but not the jets. Could a have a jet or jets partially clogged? Again, when it's warm and battery charged good, ...

Question about 1986 XJ 700 X Maxim

1 Answer

The bike has been sitting for years I took the carbs apart and cleaned them. Not starting likes its not getting gas there is gas in float bowl. Is it lack of air or a clogged jet or? clogged jet

...have an 1985 Yamaha 700 Maxium I wonder what the fuel problem was. It kind of sounds like the idle jet, and/or low speed jet needs to be cleaned. Also while your in there, i would clean all the

Question about 1985 XJ 700 X Maxim

0 Answer

...not properly adjusted. 3. Inlet system air leak. 4. Leaking accelerator pump. 5. Loose low-speed jet. 6. Plugged low-speed jet. 7. Contaminated or plugged low-speed circuit. 8. Enrichner ...

Question about 1986 XJ 700 X Maxim

0 Answer

...screw set too low. 8. Air/fuel mixture screw set too lean. 9. Idle port, transfer ports, slow air jet clogged. 10. Slow fuel jet clogged. 11. Faulty fuel pump. For more information about your issue ...

...not properly adjusted. 3. Inlet system air leak. 4. Leaking accelerator pump. 5. Loose low-speed jet. 6. Plugged low-speed jet. 7. Contaminated or plugged low-speed circuit. 8. Enrichner ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...