...sub. i was listening to it kinda loud and now the power light wont even come on and it smells burnt. is this one done for good? from my experience's, this model is not that good a lot of people have ...
JBL sub PSW-D110 hums, and the fuse is blown Hi, I have a JBL subwoofer modeled PSW-D110 and the fuse is blown. if I replace the fuse, it hums. There are several components seem blown. One of the cap ...
JBL d110 /w no sound output I recently purchased a used d110 and am getting no output out of it. Led on front stays red. If i partially remove one of the RCAs i will get a loud hum, but no results ...
...sub amp's Low Pass Input or speaker level to the sub's Speaker In terminals. Are you slaving your Front Speakers out the back of the sub or are they on the receiver? Experiment with them
...amp outputs. If it doesnt blow, stays on but no sound, problem also likely to be output stage. You will need someone with experience to check outputs, etc and a meter though. Hope that helps a bit. ...
...speakers) running off of any music sound source. You wouldn't hear anything above 180hz. I sorry but you have an internal fault in the Sub. If it's not covered by the maker, open it and look inside. ...
...JBL sub is about 11 years old and is a powered subwoofer. The onkyo was purchased about the same time. I have two options to hook up in the back receiver left and right out to sub then back to ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions