Question about Lite 2 Natural Gas Pilot Light Heater
Jandy, Lite 2 Pool heater wont kick in is there a specific size pile line needed to go to Jandy, Lite 2 pool heater? Thank you 3/4 pipe line will work and will keep heater from sooting up.
Question about JANDY LITE 125K BTU NATURAL GAS POOL HEATER ELEC I -
...Jandy Lite2 pool heater keeps flashing when turned on. First it dispaly everything when functioning normally and then changes to showing the number 113 in the bottom right hand corner. This keeps ...
Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
...have a 10 year old Jandy RS4 controller which is displaying a Water Sensor Opened command and my pool/spa heater will not turn on. What do I have to do to fix this issue? must replace water tem ...
Question about AquaLink RS2/6 All Button Dual Equipment -
...Jandy Auqulink is working fine except the select button does not seem toconnect to any command . It has a full battery charge. We have been repairing quite a few of these controllers lately. Much ...
Question about Lite 2 Natural Gas Pilot Light Heater
jandy lite 2 heater control panel will not shut off when I press the off button on the panel. it displays "invalid comman" I just replaced the Heater Control Assembly and while that resolved
Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
jandy pool heater will not heat ext sw1 my jandy pool heater will not heat. code ext sw 1 appears check safety circuit
Question about JANDY LITE 125K BTU NATURAL GAS POOL HEATER ELEC I -
Jandy XLI250 has a no flow code, even though there is flow. Jandy XLI250 pool heater 2008 check pressure switch and copper tube for obstuctions
jandy lx 250 invalid command message unable to turn heater on. "invalid command" displays on LED screen is unit on a controller if so take off remote
Question about Laars Lite2 Lj 250,000 Btu Heater
jandy lite 2 pool heater. display flashes all segments on/off when off 114 appears on display Jandy lite 2 pool heater flashes all lighte on the off. when off 114 shows on display. bad temp sensor ...
Question about Laars Lite2 Lj 250,000 Btu Heater
I have an invalid command on jandy lite 2 heater .any help with a fix is it connected to a controller if not take off remote and put on manual
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions