...and I resisted this advice for a while. Once I finally did, the job went much quicker. I placed a jack under the oil pan (with a block of wood between jack and oil pan) and then upped the jack
Question about 2007 Sorento 4x4
How do I change the wheel on a Kia Sorento 2008 (no manual) I have no manual but can locate the jack and wheel, but not sure how exactly to go about it, eg where to place jack. start by breaking the ...
Have 2001 Kia Sportage. No jack. Looks like a normal scissor jack. Any special jack placement or instructions No its just a scisser jack wity a slot cut in yhe top of it
Where do i place the jack on the rear end of the vehicle Just put the jack in the middle of the frame and jack up one side at a time. Make sure this is a real floor jack and not the one included with ...
...torque wrench, 3/8" drive 1/2" drive sockets, large screwdriver, screw in front caliper compressor, jack, jack stands, fluid catcher (pale), wrench set, etc. Hope this helps. Check this procedure ...
in detail, how do u replace a rear coil spring on a 2002 Kia Sportage? take out lower shock bolt, jack up car in rear using the frame install jack stand on frame and pull out spring.
Have fun with this one because it is very time consuming task to do just make sure you have the car jacked up properly with jack stands to take off the car tire but the problem also here is that there
HOW TO REMOVE THE JACK loosen the nut on the jack to release the tension that holds it in place
how to replace front wheel bearing on 200 kia sportage jack it up use jack stands pull the wheel pull the cv shaft bolt take the three bolts out that hold the bearing in and reverse steps to install ...
Question about 2001 Sportage
...change the brake pads on my 2010 Kia Rio.But I'm having a hard time figuring out where to put the jack to jack it up, and then where to put the jack stands.... After you jack the vehicle up put
Usually answered in minutes!
1,074 Questions
1,065 Questions
1,058 Questions
1,036 Questions
974 Questions