Questions & Answers for: Stanley inverter overload

Its keeps blowing fuses what are you trying to use? 100 watt pretty small, could plug in cell charger..not much more!

...overload or short circuit fault condition. I have not plugged in any device to the unit yet. What's wrong? Thanks! It says 0 watts because there is no load on the inverter! Plug something in, like a ...

my stanley 1.2 gal compressor immediately blows the new fuse when i replace it You might just have an overloaded circuit, what else is on that line?

Will the 500 watt charge camera batteries it depends on what type of batteries you are talking about. If they are batteries that are charged in a AA type that uses 120 volts then it will work.

When I plegged the compressor in the motor turned slow, then stopped. I small puff of smoke came from the motor. If it does not have an external reset switch, it will have a built in thermal overload ...

The red light on my Stanley pc1a09 power inverter is always on when plugged in and the 120volt power doesn't work? POWEWR SUPPLY PROBLEM

workshop manual GA1400A IS THE KAWASAKI GA1400A GENERATOR N INVERTER GENERATOR PLEASE SEND YOUR REPLY TO [email protected]

when i connect my inverter to dc power supply all fuses blow DC input is polarity sensitive. This means that the positive input to the inverter must connect to the positive (+) side of the battery. ...

Where do I find the fuse on a Stanley 800 Watt inverter On the Stanley 800 watt inverter there is an exposed fuse bridge link soldered on that will melt when connected at reverse polarity. It is ...

i have stanley 8000s generator and i have blown 4 capacitors . unit runs house for about 35 mins and then no power being put out... if burnt caps possible cause spike on output or overload Which ...