Questions & Answers for: Land Rover Freelander intake plenum torque

...intake plenum off a 02 freelander I have all the sensors,vacuum lines off etc..... all bolts that I see, its definately loose but not coming off. My 2002 Land Rover Freelander V6 thermostat crapped ...

...intake and plenum gaskets.. Not to hard.. If you can get a haynes manual to help you with dis and reassembly. Not terribly hard to do.. Another common problem with the Freelander (w/6 cyl gasoline ...

...intake cams up the the proper torque specs. Good Luck Boilermaker55 You need to specify engine type, but the following videos of the same engine type in MG and Rover cars should help (kv6 petrol 2.5L ...

...intake plenum bolts removed( 4 small in the rear and 4 large in the front)as specified in RAVE. intake plenum seems to be stuck. it moves back and forth a little, but when i attempt to apply upward ...

location of iat sensor on a freelander please It is in the air induction plenum. A small sensor between the air filter housing and the engine. Usually 2 wires going to it. It just pulls out of the ...

freelander 2.5 smokes bad at start up and has oil in air intake tube Leaky or worn piston rings that allow pressure to bypass them and pressurize the crankcase, causing oil to be blown out of engine ...

tightening of head bolt how many turns when tightening the head bolt on 2002 land rover freelander? When you are working on major parts to any auto, you must use a torque wrench for tightening. You ...

how to change a 1998 cadillac sedan deville starter I do not want to have to remove intake to get to the starter If it is the 4.6L engine then you must remove the intake to change the starter.

find correct torque for 2005 LR Freelander right front wheel bearing? CORRECT TORQUE FOR RIGHT FRONT WHEEL BEARING done by feel and "preload" on bearing

torque specs for connecting rods,main and heads 2005 landrover freelander 2.5 follow this link click on torque tables and look up your vehicle http://www.speedwayautoparts.com/index35.htm