how much torque is needed for the bolts on the intake manifold on a 3.3 litre engine in a 1999 crhsler concorde Intake manifold & fuel injector 200 in lbs, plenum 250 in lbs. Hope this helps, Rick
...intake plenum. 3. Disconnect electrical connector from sensor. 4. Remove camshaft position sensor bolt. 5. Pull sensor up out of the timing belt housing. Installation: If the removed sensor is ...
.... . . . . . . . . . . . . . . . . .12 N·m (105 in. lbs.) Intake Manifold Plenum Bolts . . . . . . . . . . . . . . . . . . . .28 N·m (250 in. lbs.) the pivot arm ? whats ...
...intake manifold plenum The MAP sensor is located in the rear of the intake manifold plenum on the 3.3L engine. On the 3.5L engine, the MAP sensor is threaded into the left side of the intake manifold ...
...intake plenum to get at one of the bolts that hols it in place. Its not that big of a deal to remove. Just remember to replace the plenum gasket and torque the bolts to the proper spec. If you have ...
in need the torque for the bolts to the plenum the bolts that go into the plenum to the lower intake theres 7 bolts and they need to be torqued intake manifold upper and lower 89 in. lbs.
intake plenum. Remove plenum and re install with new gasket later (It's easy). Take your new plugs and make sure thy are platinum or better and gap them for your engine.Put antiseze on the threads
Question about 1996 Concorde
...plenum from right side of vehicle. Disconnect wiper module wiring harness. Remove wiper module from cowl panel. Remove power brake booster vacuum hose from intake manifold. Position hose aside. 4. On ...
...intake plenum of a 2007 Chrysler TWC. Here are the steps: Remove covering on lower intake manifold and clean surfaces. Inspect manifold gasket condition. Gaskets can be re-used, if not damaged. ...
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions