Questions & Answers for: Lincoln Mark VIII intake manifold gasket

Question about 1993 Mark VIII

1 Answer

...intake manifold leak, we had some problems with seals used on the upper section of the intake on your engine, get a can of carb spray and spray it around the intake, see if the engine reacts, if it ...

Ad

Question about 1996 Mark VIII

2 Answers

...intake manifold runner control butterflies could be carbonned shut or open in which case the car will idle erratically. the intake will need to be removed and the runners cleaned with a brush and ...

Ad

Question about 1996 Mark VIII

2 Answers

...intake manifold runner. This is located IN the upper section of the intake manifold, and should be looked in to by a professional. It is most likely sludged or carboned up and stuck. P1537 - Intake ...

...intake manifold runner control, consists of an extra set of valves that over time can stick in one direction or the other open/closed. They are repaired by removing the intake manifold and de-gunked. ...

Question about 1996 Mark VIII

1 Answer

The air comes in through the intake and is mixed in the intake manifold or cylds. The computer and sensors regulate the amount of fuel to air intake . Did you check ror any codes . Is engine light on

Question about 1996 Mark VIII

1 Answer

where is the air intake hose? Its in the back like box that holds the AiR FiLTER, the hose would be the one that goes thru the iNTAKE MANiFOLD!

Question about 1998 Mark VIII

1 Answer

...Intake Runner Manifold Controller is not opening the secondary runners for the intake-this is a common issue on Marks, check to see if you can manually open the plates by hand, if not, it is usually ...

Question about 1996 Mark VIII

1 Answer

...Intake Manifold Runner Control Stuck Open The problem is that you are going to have a hard time finding the replacement part since Ford is not manufacturing the manifold runner control anymore. I ...

...intake manifold, since you will need to remove it any way to replace the head gaskets, while you have the intake off just pour the water out.then you may want to blow the moisture out with compressed ...

...intake manifold gaskets on 1998 Mark VIII 4.6 Labor Hours on Intake Manifold Gaskets No small task. A lot to get out of the way and replace to access intake and gaskets. Expert with proper tools 4-6 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...