Questions & Answers for: Buick intake manifold

intake manifold gasket / replace guide to replace intake gasket on 1998 olds bravaca 3.8L Engine NOTE The 3.8L (VIN K) non-supercharged engine uses a two-piece intake manifold consisting of an upper ...

intake manifold bolts torque and rocker arm torque engine specs Intake Manifold Coolant Pipe Bolt .... 89 in lbs (7.4166 ft. lbs) Lower Intake Manifold Bolt .............. 115 in. lbs (9.5833 ft. lbs)

Intake Manifold Cleaning About 2 weeks ago I had my intake manifold valve replaced. I was told that if my check engine light goes on again, my intake manifold will need to be cleaned. I was quoted ...

...intake manifold no engine lights on Carefully check all hoses & clamps. If leak/seepage not found then check for leak along the intake manifold - the manifold gasket could be leaking and this is ...

intake manifold as well as the under carriage of that same part I think. Outake? I know that the part that attaches to the manifold appears to be metal but the manifold appears to be plastic. Can this

...intake manifold on 2005 Buick Lesabre You didn't post the size of your engine so please pick the appropriate one: 3.8L Relieve the fuel system pressure. Drain the cooling system. Remove or disconnect ...

...intake manifold. Remove the solenoid valve mounting bracket and power steering support brace from the intake manifold. Disconnect the heater pipes from the intake and front cover. Remove the ...

intake manifold gasket cracks or blows out, coolant will leak out of the intake manifold. You may see puddles underneath your car or notice smoke or steam coming off of the engine and exhaust from the

...Intake Manifold To Cylinder Head Years: All Vote Record: 0/1(0%) Note: 3100 - Lower Bolts - 2 Steps: 5 FtLbs; 9.58 FtLbs Here are the head bolt torques for a 3.8 37 Ft-Lbs 444 In-Lbs 50.17 N-m ...

radiator. The thermostat is located in the intake manifold where the large upper radiator hose attaches to the intake manifold. Remove the two bolts holding the thermostat cover to the intake manifold