Questions & Answers for: how to install u joint

Question about 2002 TrailBlazer

1 Answer

...joint. Install the steering knuckle with wheel hub and bearing attached. Install the tire and wheel. Lower the vehicle. Check the front wheel alignment. these jouints are pressed in and there is a ...

Ad

...joint snap ring is fully seated. 2. Always install new: Snap rings. Castellated nuts. Cotter pins. Upper ball joint nuts. 3. Observe the following torques: Outer tie rod end castellated nut: 52 ft. ...

Ad

...Joint Installer (MB990800), install dust cover. 2. Ensure upper arm shaft assembly is installed at indicated angle. Verify upper arm shaft assembly installation. Check front wheel alignment. Once you ...

...Install the ball joint-to-lower control arm. Install a new ball joint-to-lower control arm nut. Tighten the stabilizer shaft bolts to 35 ft. lbs. (48 Nm). For 1988-91 vehicles, tighten the ball ...

Question about 2002 Silverado 2500HD

1 Answer

...Install the joint spider assembly to the shaft and install the snap ring. Fill the inside of the boot with the specified grease. Often the grease supplied in the replacement parts kit is meant to be ...

install CV-joint boot protector tool J-34754 or equivalent, to protect the boot. On Eldorado and Seville with 4.6L engine, remove the road sensing suspension position sensor from the lower control arm

...joint assembly. Install Remover, Special Tool 6919 on the top of the ball joint assembly. Using the arbor press, press the ball joint assembly completely out of the lower control arm. NOTE: When ...

Question about 2000 Caravan

1 Answer

install the upper ball joint, assemble C-frame assembly, Ball Joint Receiver Cup D81T-3010-A5 and Installation Cup D81T-3010-A1 and D81T-3010-A3 or equivalents inside cup D81T-3010-A4 or equivalent in

Question about 2003 Sunfire

1 Answer

...Install the ball joint (4) into the control arm (2).Install the 3 ball joint bolts (3) and the nuts (1). Follow the instructions in the ball joint kit. Tighten the ball joint bolts (3) according to ...

...joint To install: Install or connect the following: Inner CV-joint and snapring Inner joint balls Spacer and snapring Inner joint housing and circlip. Add 150 grams CV-joint grease. CV-joint boot ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...