...intake manifold and return to the radiator like in the old days It may be that the thermostat is not the proper one needed to regulate heater temperature operation. Check the thermostat. It may be ...
intake manifold bracket and install the upper bolts Starter into position. When aligned properly torque the bolts to 40 ft. lbs. (54 Nm). Torque the intake manifold bracket bolts to 40 ft. lbs. (54 Nm
...intake manifold then you have to remove battery tray clean up the ground there then clean where the tray bolts up as this aids in chassis grounding remove ground cable from bellhousing before you ...
...intake manifold bracket bolts Front 3 axle housing mounting bolts, 4WD only Left front bushing from the axle housing mount and lower the front axle housing Both gusset plates from the engine ...
...Install intake manifolds bracket and 4 bolts. Tighten bolts to 32 ft lb (45 Nm). Install grounding bracket. Connect fuel hose to fuel connector assembly. Connect the following electrical connectors; ...
...intake manifold bracket bolts and bracket. Remove two upper starter bolts and a lower bolt. Pull starter from clutch (M/T)or converter (A/T) housing and prop in place. From above, disconnect starter ...
...BOLTS AND REMOVE BRACKET.REMOVE STARTER FROM TRANSMISSION.REMOVE STARTER ELECTRICAL WIRES.INSTALL NEW STARTER BACK VISA VERSA. TORQUE STARTER BOLTS 40 FT LBS TORQUE INTAKE BRACKET BOLTS 40 FT
...Install or connect the following: Cylinder head with the intake and exhaust manifolds attached 3 wiring connectors at the rear of the cylinder head Fig. Cylinder head torque sequence-Kia Sportage ...
Usually answered in minutes!
1,074 Questions
1,058 Questions
918 Questions
753 Questions
343 Questions