...intake manifold and remove the entire head, intake, and exhaust manifold in one piece. Of course this is just personal preference. Otherwise you will have to buy all new gaskets for the exhaust ...
...install intake manifold gaskets and their location. Im installing a intake manifold and need to know which way the gasket block plates face. Do the gasket block off plates go front or back How do I ...
...a hissing sound and then it shuts off open the hood up and look for a missing vacuum port plug on the engine intake manifold, sounds like the case here, that would cause a really loud hissing
...skylark we did a head job on it now when we crank it up it shut back down VALVE TIMING OR IGNITION TIMING OFF YOU ALSO COULD HAVE A INTAKE MANIFOLD VACUUM LEAK.MAKE SURE YOU DID ADJUST VALVE
...intake manifold gasket. Sometimes the lifters will bleed down and it should run, but run bad for a few minutes. Be sure you put the pushrods on correctly, the intakes are a different length that the ...
...anitfreeze and oil Could be a blown head gasket...or a loose intake manifold. hard to tell without further description where it leaking from if you no where its comeing from could tell you how to ...
94 Buick Skylark, 3.1L, engine wont start after replacing intake manifold gasket. It started and ran before gasket replacement. did you put the long pushrods in the correct rocker arms?
...intake manifold gasket was being replaced. YES I'm aware that the intake rods are 5 3/4" and the exhaust rods are 6", they were reinstalled correctly. Has anyone had experience with the ...
will a Buick nail head intake manifold fit a 1971 Buick 350 engine??? NO !!!!!!!!
...intake manifold. Install the mounting bolt and nut. Tighten to 18 ft. lbs. (25 Nm) for the 3.1L engine. For the 3.3L engine, tighten to 20 ft. lbs. (27 Nm). Install the air cleaner assembly. Connect ...
Usually answered in minutes!
346 Questions
224 Questions
182 Questions
155 Questions
143 Questions
