Questions & Answers for: Chevrolet how to install a intake manifold

...intake manifold. Install the mounting bolt and nut. Tighten to 18 ft. lbs. (25 Nm) Install the air cleaner assembly. Connect the surge tank line to thermostat housing. Refill the cooling system. ...

...would install a edelbrock intake manifold and carburetor as a matched set.You can purchase a edelbrock carburetor and intake manifold from advance auto parts that's designed for your

...Install the lower intake manifold. Tighten the bolts in sequence and in 3 steps, as follows: Step 1: 26 inch lbs. (3 Nm). Step 2: 106 inch lbs. (12 Nm). Step 3: 133 inch. lbs. (15 Nm). Install or ...

...Install lower the intake manifold attaching bolts. Apply sealant or equivalent thread locking compound to the threads of bolts. Tighten the vertical bolts first, then the diagonal bolts to 115 inch ...

...Install the upper intake manifold gasket. 2. Install the upper intake manifold. Use care not to pinch the injector lines between the upper and lower intake manifolds. 3. Install the upper intake ...

...Intake manifold bolt tightening sequence-1996-98 4.3L engines Install the bolts and tighten in sequence and in 3 steps as follows: First step to 26 inch lbs. (3 Nm). Second step to 106 inch lbs. (12 ...

Install the lower intake manifold bolts. Notice: Proper lower intake manifold fastener tightening sequence and torque is critical. Always follow the tightening sequence, and torque the intake manifold

Install the intake manifold gaskets with the port blocking plates facing the rear of the engine. Factory gaskets should have the words "This Side Up" visible. Apply gasket sealer to the front and rear

intake manifold bolts prior to installation. On the 5.0L and 5.7L engines, install the bolts and torque in sequence as follows:    Step 1: 71 inch lbs. (8 Nm).     &

...intake manifold and manifold gasket. Disconnect the throttle body inlet duct from the engine. Twist off the radiator cap to allow draining of the coolant to flow more smoothly. Place an empty ...