Questions & Answers for: install 2002 hyundai xg350

Rough idle after new plugs and fluctuating RPM's I just recently got my plugs and wire's changed and the car is now rough idle, and my RPM's i've noticed are fluctuating sometimes to the point where i

Ad

...day car would not start, tried to jump it but would not turn over at all. Bought new battery and installed it. The alarm went off, all the lights work but car will not turn over (like trying to ...

Ad

...i have a 2002 hyundi 350xl and the engine belt tensioner is squeaking i just had a new alternator installed approx 1 yr ago. i also noticed that the eng plastic shroud is rubbing on one of the ...

Question about 2002 XG350

1 Answer

2002 hyundia, to replace the stud, Knuckle needs to be removed and the center hub 'pressed out' using a hydraulic press (accepted procedure). You can avoid this by using an air hammer and disk cutting

Question about 2002 XG350

1 Answer

...HYUNDAI XG 350 loosen tentioner pully belt... using a 14 mm wrench, release tension on the belt by loosening the 14mm bolt. when loose enough, remove belt.. then install NEW belt.. adjust tension on ...

...FUEL FILTER IN MY 2004 HYUNDAI XG350 AND NOW I CANT GET IT TO START make sure you installed the filter correctly the is normally " in " and " out " marks on it., installed wrong and fuel cannot

...2002 Hyundai XG350 3.5L MFI DOHC 6cylWater Pump - Removal & Installation Before servicing the vehicle, refer to the Precautions section. Drain the cooling system. Remove or disconnect the ...

Question about 2002 XG350

1 Answer

2002 Hyundai XG350. Today I went to get a remote start/keyless entry installed. When I left the shop I noticed the TCS light was on. I was running late for class so I had no time to stop and ask about

Hyundai, 2002 XG 350 has a P1191 code that comes up, the car will run rough and sounds like it wants to cough when you start to push down on the gas pedal. We have replaced the plugs and three wir Our

...2002 Hyundai XG 350L that will not start. It will turn over but will not start. Its not getting fuel or spark. I've replaced the fuel pump, crankshaft sensor, camshaft sensor, this website has books ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...