...insert a putty knife in between the main top and the front of machine, perhaps 3 nches in on either side and "pop" the clips holding down the lid, HOLDING the lid assy (cause its spring loaded nad ...
...knife adn insert it about 3 inches in from either side t o "pop" the top hold down clips, the main lid assy will the tip back wards, next remove the outer tub cover (10 or so clips holding around the ...
knife and insert one inch at the middle and slide until you feel it stop. This is a clip and the other side has one too. We need to use the knife and push in the clip about 1/2 inch and lift that side
...knife straight in from the front at each corner and push in while lifting up. You should feel the release tabs push in and the console will pop up. Or, you may have a console that has removable end ...
insert a putty knife in the seam where the top panel meets the front. About two inches in from each side is a retaining clip that you must push in on while lifting up. Release each side and the entire
knife (easier) or a small flat head screw driver (a bit more difficult) push one of the green clips towards the rear of the machine while lifting on the top (warning they are very stiff). You can wrap
...insert putty knife or butter knife between front seam of cabanet and top. about 2 inches from left side and 2 inches from right side push in and pull up on top. lid switch is located under ...
Usually answered in minutes!
2,624 Questions
57 Questions
48 Questions
24 Questions