Questions & Answers for: Mitsubishi Endeavor input turbine speed sensor

Question about 2004 Endeavor

1 Answer

...speed or applied, the anti lock brakes will engage and you can feel the the brakes shake. The brake pads have been replaced and it still happens very know and then. I'm looking for help to find a ...

Ad

Question about 2004 Endeavor

2 Answers

...speed range of about about 300-500 rpm in the top 3 gears when lightly pulling. does not start until engine is warm. it starts around 1100-1300 rpm. A faulty O2 sensor was replaced and greatly ...

Ad

Question about 2004 Endeavor

2 Answers

...speed it stops shaking/shuddering It drives fine on the highway, it's the city driving with the stop and go that I have the problems. I just had the vehicle check over a week previous to the problems ...

Question about 2004 Endeavor

1 Answer

Low speed shudder as well I have a low-speed shudder with my 05 Endeavor as well. it occurs at about 35-40 mph under slight load (slight uphill). the rpm is about 1,400. it does not occur when you ...

...sensor on the air horn.Why do people who have no clue bother answering? The idle speed is controled by the throttle body which allows a specific amount of air to flow into the engine thus controlling ...

Question about 2005 Endeavor

1 Answer

my service engine light is on. and I took it too autozone to be checked and got the results: Large vacuum leak on engine, 2. throttle body condition-dirty and faulty IAC valve/throttle. what does this

Question about 2004 Endeavor

1 Answer

car sputter when you step on gas (speed between 0 to 39) how can the problem be fix and is there a recall on problem. my e-mail is [email protected] CHANGE THE MASS AIR FLOW SENSOR

Question about 2004 Endeavor

1 Answer

...being on ,doesn't mean you have to replace the pump on a 6 or 7 year old vehicle. Could be a wheel speed sensor Cost doesn't matter,it has be diagnosed and resolved,it can not be safely used, as

If im looking straightforward at my engine what side is my a/t input speed sensor located What car or truck? Buy a repair manual! WHY DO PEOPLE OMIT PERTINENT INFORMATION?

Input Turbine Speed Sensor Circuit Malfunction - Input/Turbine Speed Sensor Circuit Malfunction - Wiring problem ! Check for 5 volts on the white an violet wire at the input speed sensor . Check for b

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...