...input. • Engine Shutdown Mode--The control module will disable fuel and de-energize the throttle actuator. Throttle Body Assembly The throttle body for the throttle actuator control (TAC) system is ...
Question about 2009 Envoy
...mode. If the discrete ignition input is not active, open or 0 voltage, the modules will fail-safe to OFF-AWAKE. In this state the modules are constantly checking for a change status message on the ...
...mode. The normal battery voltage input to the HDM must be between 6 and 16 volts DC to operate. Any deviation to these values could cause improper operation. Major components of this system are the ...
...input from a SPS that state 1 threshold is reached (seat is rearward) the SDM will not disable stage 2 deployment, if required by the deployment sensors. When state 2 threshold is reached (seat is ...
Question about 2005 Envoy
...input. • Engine Shutdown Mode--The control module will disable fuel and de-energize the throttle actuator. There are DTC'S -diagnostic trouble codes stored in the PCM , could have throttle position ...
Question about 2005 Envoy
...lamp intensity using the ambient light sensor, multifunction switch and the park brake switch as inputs. In general, the HDM will operate in 1 of 3 modes: Your best bet have it checked by a ...
...input to the BCM. The requested rear wiper mode is sent to the liftgate control module (LGM) by the BCM as a message on the serial data circuit, and the rear window wiper motor is controlled by the ...
...or by controlling fuel and spark if throttle is turned off. - Ignore accelerator pedal input. • Engine Shutdown Mode--The control module will disable fuel and de-energize the throttle
Usually answered in minutes!
2,225 Questions
1,368 Questions
1,418 Questions
593 Questions
540 Questions