...if you start it and incline reads more than o when pressed it is fuse it is lokacted on motor controll board there is 2 one for drive motor one for elevation motor cll if assistance needed 347 515 ...
...incline as you describe. I toubleshooted(?) the condition and found that the nylon gear (28,81 or both) was stripped. I ordered a replacement for a few dollars and installed it. Work carefully and be ...
incline motor pipe to the 0% position. This happens when the red line on the thin pipe is even with the end of the thick pipe. Electronic calibration sets the variable resistor (VR) value to
Question about 6300 Treadmill
...incline motor keeps blowing. I have replaced the fuse 3 times but as soon as I change the incline the fuse glows orange and burns out. Any idea what could be the cause ? Be sure you're replacing ...
...incline motor operates, and the display board CPU uses the VR voltage to calculate the incline position. Without this value, the CPU cannot instruct the incline motor what to do, so ERR? appears. Or ...
Usually answered in minutes!
43 Questions
2 Questions
2 Questions
3 Questions