Question about DR-2580C Path-Through Scanner
Streaks in image scanned by Canon DR-2580C Path-Through I had an unfortunate incident where some pages with staples were fed through the scanner. As a result, the sensors must have been ...
...say you view on a monitor where the Brightness & Contrast are not proper, you will see the image poorly! To test the scanning scan absolute white and check the output. It should read the ...
...to roll even after the end of the page, and no image was displayed The paper sensor must be checked. Check if there is a speck of paper stuck inside the sensor. Blow with a vacuum cleaner. S. ...
Question about DR-2050C Path-Through Scanner
Canon DR-2050C Scanner gets verticle line down image I have a Canon DR-2050C Scanner and it often produced a verticle line on the image. A person on this website says to "clean the glass;" however ...
Question about DR-6080 Path-Through Scanner
What does a Red 1 and a Red 3 on the Quma tool Dcon mean? Images skewd, dark boarder on top and cutoff at bottom of document. Heard about Quma tool on FixYa. Found the software. Password protected. No
...inside the scanner. If a document is skewed slightly, the scanning software can deskew the image. If skewed too much the scanner would ask you to rescan. The scanner senses the document thro ...
...Image Sensor' or CIS. The page to be scanned must be close to the glass for a proper image. This is achieved by a full-length rubber roller just above/below the scanning module. The roller is ...
Usually answered in minutes!
188 Questions
58 Questions
64 Questions
33 Questions
38 Questions