Questions & Answers for: ignition timing 1989 toyota corolla

Ad

Question about 1989 Corolla 2 Door

1 Answer

...1989 Toyota Corolla I believe it is the deluxe model, (Very plain.) I have a hard time locating the drain plug. I am afraid that the bolt will not be easy in removing it. Since i have never fully ...

Ad

Question about 1989 Corolla 2 Door

1 Answer

...car creeps and takes a while before chipping into low gear , all of the above is even worse when my car has people in it Have you ignition timing checked. It seems you have a retarted ignition

Ad

Question about 1989 Corolla 2 Door

1 Answer

...1989 Corolla GTS with 4AGE. 1. As I turn the ignition key to "On" (the engine not yet running) the tachometer immediately reads 2000 rpm. Most of the time also, the tach gets stucked at 2000 rpm when ...

Question about 1989 Corolla 2 Door

1 Answer

Stereo stays on when key is turned off. The stereo will turn off with the key sometimes but will come back on at any given time. There is probably a short circuit in your ignition switch.

Question about 1989 Corolla 2 Door

2 Answers

car is not getting spark check your fuses first check your ignition coil for burn or crack if not then replace the whole distributor, because the distributor has a life time warranty. if you buy the ...

...seal and when turning it of after driving you can rev the engine up a bit then immediately turn ignition off, this will leave enough fuel in fuel line when started the next day. Good? Does the ...

...timing and ignition timing correct.it is an electronic distributor, The problem started three days ago by missfiring and looses power. check cam or crank senso if distributorless ignition if as ...

...ignition coil, adjust timing and cleaned my carburetor. Sounds like an intake manifold leak. Once the manifold gets hot the gasket leaks. I would check that first and the head gasket second. Are you ...

Question about 1989 Corolla 2 Door

1 Answer

ignition timing for 1989 toyota corrolla adjusting timing 1988-95 MODELSSee Figures 6, 7, 8, 9, 10 and 11This service procedure is for setting base ignition timing. Refer to underhood emission sticker

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22533 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...