Questions & Answers for: ignition switch dodge caliber sxt

...dodge caliber thanks i doubt if you will get one ,these newer vehicles use encrypted software and modules so they do not use wires as such ,only 5 cables -two bus lines a perm 12v feed a earth and a ...

...ignition switch harness wire or there are many other possibilities too. Click the link below and follow the instructions to troubleshoot the ...

...ignition switch, which was quite often an intermittent thing. My Daughters car is same, and it had to go in to have part of the system changed ( can't remember for sure if it was switch itself or ...

...ignition switch,or the alarm, If you have a alarm problem the vehicle will crank then in 2 seconds shut down,this is because the key is recognized,now if this is the problem roll down a window and ...

My dodge caliber will not start. The lights will come on but it will not crank. And there is a red light on battery flat ? bad ignition switch ? imobiliser activated ?

...dodge caliber U0100 No start Was running perfect until I went to start it last night and got nothing. All lights come on but no crank. Had my mechanic test the battery and it was bad, replaced the ...

...not start Ok I have a 08 dodge caliber SXT 2.0 i have a no start issue turn key get no crank. the anti theft is not staying on.new starter new battary changes fuses check out your ignition switch

...dodge calibers, the relay box harness gets corroded by it being near the front driver wheel. Rain puddles and snow will eventually get inside and cause corrosion. The relay switches that are inside ...

...ignition switch problem or an open circuit between the ignition switch and starter solenoid... if you do have power in the crank position then you have a bad starter. I have a 2007 dodge caliber sxt, ...