Questions & Answers for: Pontiac Grand Am ignition switch

Ignition Switch I need to know where to locate the ignition switch on my 96 grand am se 2.4l ignition switch is located on the steering colum , right hand side , opposite side of the turn signals.!

ignition switch from OFF to RUN (maintain the ignition switch in RUN for three seconds, but no more than ten seconds). -Turn the ignition switch to OFF and remove the first coded key from the ignition

...successfully. To exit the transmitter programming/diagnostic mode perform either of the following: ? Turn the ignition switch to the RUN position. ? Remove the ignition key from the ignition ...

...ignition switch is usually mounted to the steering column and is operated by a linkage rod. NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ...

...ignition switch it self may be going bad and may need to be replaced. If you have many keys on your key chain, this will promote the ignition keys to fail. The ignition switch's job became more ...

...ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are having problems with your ...

...ignition switch out and check for burned ignition switch wires and worn ignition key tumblers and ignition lock cylinder.These cars are known for faulty ignition switches and ignition lock ...

ignition switch ignition switch wires There are several wires going to and from the ignition switch.  What are you trying to fix? When I turn off the ignition the radio continues to stay on. Even

...ignition switch fuse under the hood in the power distribution center good, check for 12V at YEL wire (from ignition switch) at the switch when ignition moved to START position. If 12V present at YEL, ...

...ignition switch problem , GM has had switch problems for sure . The starting of your vehicle is computer controlled by the BCM - body control module . The ignition switch could be sending a wrong ...