...relay. check fuse and relays. replace with the same type, you could try to interchange the relays if they are of the same type. i have a 95 chevy lumina car and it will not start from the ignition if ...
...relay receptacle with 12V and the horn honked. So I seem to have verified that all of the components and individual circuits are operating properly, but the system as a whole is inoperative. Any ...
...You are not grounding the starter but jumping across the solenoid? First place to check is the ignition security chip in the lock cylinder. Then the relay, ign switch itself and neutral safety
...the ignition in the dash correct sounds like you may have a faulty or wrong ignition switch but there is a starter relay either on the firewall or under the dash im not sure on location hope this ...
...relay for power and the main connector power at the tank only getting .3vdc at any of the hot pins during the ignition switch to on and a short jog of the engine. Were not sure the pump is bad. did ...
...starter/selonoid, it will run but flashes "security". It will not start with the key...why? your ignition switch is out of adjustment or a bad ignition switch or a blown fuesable link!! also ther ...
...ignition key lock cylinder, theft deterrent module (except Century) or BCM (Century), theft deterrent relay and Powertrain Control Module (PCM). The PASS-Key II(R) system can also be supplied as a ...
...ignition. If the fuel-pump relay is not working, you can "jump" the unit with a small lead jumper cable. You will need to access the fuse panel and insert the cable into the relay unit; the unit will ...
Ignition Relay in my fuse box, figuring that this would facilitate my fans coming on when the key was turned on. (because my car had a tendency to overheat, because the fans do not come on soon enough
Where is the starter relay (or ignition relay switch) located at in a 1996 chevy lumina? IN ONE OF THE FUSE PANELS.
Usually answered in minutes!
964 Questions
809 Questions
661 Questions
639 Questions
448 Questions