Questions & Answers for: ignition module overheating

...ignition module. check for spark when it is in the no start condition. Ignition modules are expensive so i would have it checked by a garage before replacing it. May be an ignition module or coil ...

...ignition control module is going bad----once that starts heating up it's like a circuit breaker that cuts out(stalls)----that needs to cool down before restarting. The truck prolly runs like a champ ...

...ignition module burning out is because of the ignition coil, and you should try replacing the ignition coil and the ignition module both together, and be sure to clean out the distributor mounting ...

ignition module inside of the distributor could be faulty, or the ECM (Engine Control Module) could be faulty, and the ECM's that were manufactured back then were prone to faults, and that is also why

...ignition module. Check the oil level, low oil level will cause overheating. Check the cooling fins, clogged fins will cause overheating. The ignition module will need to be replaced for a long term ...

ignition module fail REPEATEDLY over the last 6 months. Auto shop has replaced it ever time, which gets the truck to run again, but only to have it fail again a few weeks later. they have replaced all

...ignition module . may be getting hot and results in loss of power. On distributor-equipped GM vehicles, the ignition module is usually located inside the distributor housing. Ignition module ...

...ignition control module or the ECM itself there could be components that ore overheating and failing or shorting and overheating and failing The ECM you can test by getting a known good unit and ...

...ignition module it could if overheating from short or grounding and is drawing extreme amount of amps /power --but check and have tested battery -battery connections =loose or corrosion-- test and ...

...replaced feul pump, any suggestions? problem component in the ignition control module overheating and switching the module off the backfire is an in appropriate spark time from a problem control ...