...module thet in turn controlls the starter and sends a signal to the engine computer. Use a resistor of the same resistamce value as in one of the keys for the car (measure resistors with a digital ...
ignition control module tested. if all this seems fine in working order try replacing the crankshaft sensor, located inside the harmonic balancer. probably should replace the spark plugs and does make
...ignition, the keyswitch sends a signal to the vats module wich verifies the resistance and sends a signal to the cars computer that turns on the signal for the fuel injectors and enables the starter. ...
...ignition the keyswitch sends a signal to the vats module wich verifies the resistance and sends a signal to the cars computer that turns on the signal for the fuel injectors and enables the starter. ...
ignition module on1995 buick my car started acting funny so we changed the 1&4 coil pack and the tension pully...even with the 1&4 coil pack replaced they still arent firing. i was told it was
...ignition module, knock sensor and PCM (powertrain control module). The engine relies on the ignition spark to be delivered to the combustion camber at the correct time. If the ignition spark stops or ...
...ignition module located under the coil packs. the crank sensor is located behind the balancer on the lower part of engine.if possible you need to check for signal form the sensor to the ignition ...
Question about 1995 LeSabre
...is located on the lower front of the engine. If you're not sure of it's exact location, you can trace where your spark plugs wires go. They lead to the coils, which are mounted to the ignition
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions