Questions & Answers for: ignition mod

ignition mod have you ever known a module to work then not work intermittenly? yes it is possible ...i worked on a cavalier a few years ago it did the same thing, i finely swapped ignition.mods. and ...

...ignition. could you tell me more? Sure mate. There is a cool mod you can do, where you are left with a fuseholder under the seat that bypasses all the safeties, wiring, kill switch, ignition switch ...

...ignition module has failed. Check for 12 volts to mod and replace mod if voltage is good. I think you have the VORTEC set-up, look at the CKP & CMP sensor, ECT, TP sensor, IAC, ignition switch, ...

gas dryer mod.# MDG6000BWW, Igniter lights but no flame gas dryer mod.# MDG6000BWW, Igniter lights but goes out after a few seconds , no flame. worked once after i replaced the igniter. Replace the ...

cant find electronic ignition module on the engine of my 1994 Ford Taurus 3.8 litre CHECK AT CRUZ CONTROL MOD OUTSIDE BOX IS IGN .MOD

...tractor mod.# 944.600031 ser.#o52300c 002355 key # 140403 and my problem is I need ignition switch part number Ignition switch is Part Number 163968 +sears carry some ignition switches on the

...ignition mod off of the distributor base plate with plastic washers to reduce heat conduction. The fasteners that secure the ignition module to the base plate also ground it.. so make sure they are ...

ignition mod tests good. Even though your ignition mod tests good, you should try a different one. The tests do not always show a fault. What is happening is, your ignition is not getting enough power

mod and all my settings I changed are gone. Have you connected the Yello and Red wire to the ignition?Or your Yellow and Red are reverseYellow must be connected to the Battery (always 12V) to keep the

How to do a ignition relay mod on a 1993 pathfinder There are so many mods to do on an ignition system that you are going to have to be more specific as to what you are trying to achieve.........