ignition switch turned all the way around and landed in my hand key and all what should i do you can either put that back in make sure the push pin on bottom is sticking out and make sure you can push
...ignition switch in my 1990 E150 the old one came out while i was starting it i put it back in and it just keeps turning around my problem is if i buy a new one i'm not sure how to install it If it ...
...lock this in The ignition is suppose to be in the forward acc position when removed -make sure the inside is set for that-also the pin depress needs to spring back out in to the hole of the housing ...
...ignition module On my 89e150 its located on the distributor screw Wwws arent accessible so u have to matchmark the shaft to manifold (white out, sharpie, scratch) rotate the distributor, remove the 2 ...
...Ignition Switch Lock Cylinder-Functional Lock CylinderRemoval Disconnect the battery ground cable (14301) and wait at least one minute. For additional information, refer to Section 414-01.Remove the ...
...lock. Now run the machine screws into the threaded drift pins on both sides that the assembly pivots on. Now to pull the pins clamp vise-grips on the screw and lightly tap them out with the hammer ...
...lock in place also.9Insert the fuel pump relay back into the fuse panel. This will pressurize the fuel system.10Turn the ignition to the "start" position and allow the fuel pump to prime itself and ...
Usually answered in minutes!
22 Questions
222 Questions