Questions & Answers for: Ford F-250 ignition fuse

no power to starter soleniod from ignition As the ignition switch provides the low current power for the starter solenoid you need to hook a 12v tester up and trace the wiring backwards after checking

...THAT DID'T DROP OUT THE PRE-START UP HEATER AFTER START UP. THE RETURN SPRING IN THE SWITCH IS WEAK, SO I HAVE TO REMEMBER TO MANUALLY BACK OFF THE IGNITION SWITCH OR THE FUSE BLOWS IN ABOUT 20

...ignition switch on steering column. Is there a fuse somewhere that I should check? Operators manual does not show one. Dealer says there 'may' be but does not know. the main ignitin should be fused. ...

...to do is run a wire from the ignition switch to the coil this will get it going. CHECK IGNITION FUSE TO COIL.IF NO DASH LIGHTS COME ON.IGNITION ACC FUSE NOT BLOWN COULD HAVE FAULTY IGNITION

...and check the rotor arm and the contacts for wear CHANGE DISTRIBUTOR CAP AND ROTOR.IF ALL READY DONE.IGNITION MODULE OR COIL COULD BE FAULTY.CHECK IGNITION FUSE TO SEE IF IGNITION COIL GETTING

...compartment near the brake master cylinder. Look position 20, 50AMP (Maxi Fuse) for Ignition Switch (B4 & B5) ans position 21 (same sizes) for Ignition Switch (B1 & B3)... Keep us

...fuse block for the ignition. I've traced it allthe way thru the fire wall and I still have no power. I have changed the ignition switch and thats when the problem occured. Do you have any suggestions ...

...ignition fuse WHICH ignition fuse? There are at least 3 fuses associated with your ignition system. What is it you are trying to fix? Please review the following article and get back to me: ...

ignition fuse if yes getting power at ignition coil.either ignition coil is bad or thick film module on distibutor faulty.ignition timing way off or you have worn distributor cap and rotor. worn spark

ignition switch ON position the door ajar switches The output is the instrument cluster chime. Jeff answered this while I had an internet outage. No fuse. There is a way to turn it off though. https:/