Question about 1996 Skylark
ignition fuse to get it to turn off. Before pulling fuse, much of the electrical system wouldn't work either. If I put Started car, went to turn it off and key won't turn off or come out. I pulled the
...ignition again, got nothing, no battery turn over, nothing. Start by checking the fuses and then the battery connections, this sounds like a fuse poped maybe a main fuse, if its a fuse then replace ...
no radio the fuses in the box r ok is there any fuses i dont know about how can i fix it? The ignition runs on the 20 amp PCM fuse. Did you check that one? It may be in the engine compartment fuse box
...the ignition different pins are pushed to make an electrical contact. the easiest way to veriry this is to remove the ignition fuse not dash fuse It will stiill need to be verified by voltage ...
Question about 1996 Century
...IGNIYION COIL FUSE KEEP BLOWING 1996 BUICK CENTUREY EVERY TIME I GO TO IGNTION MODE MY FUSE POP Check this site for ignition fuse blow issues: ignition fuse keeps blowing Car Forums and Automotive ...
Question about 2001 LeSabre
...dash lights etc. would point to blown fuse/fuses. Even if the ignition switch was faulty you should still be able to switch the headlights on. I would check the fuses and the ignition switch
Question about 1992 LeSabre
...fuse circuit for voltage. During cranking rpms, it is the ignition module that controls spark, but, it has to see rpm signal, which comes from crank sensor. At the moment, I can't be positive which ...
Question about 2003 Rendezvous
...fuse for the ignition control module , fuse #13 ELEC/ENG 15amp . in the under hood fuse box . The odds of the fuse being bad are astronomical . More likely that ignition module or a crankshaft ...
...fuse blows instantly. I've replaced my ignition switch and fixed my ignition column yet its still blows. What do I do? pcm fuse blows instantly ???? What number fuse , how many amps ? Where is it ...
Question about 2003 Rendezvous
fuse for the ignition module , ELEK IGN 15 amp . Really don't think this would be your problem , more then likely the crankshaft position sensor or the ignition module is . Your best bet have it towed
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions