Questions & Answers for: ign relay switch

...ign is turned of I reckon you have the wrong type of relay fitted (has it always been like this)??? you need a "normally open" relay, (eg it is off until it gets power) it sounds like you have a ...

ign switch..relay replaced..starter..ign switch..relay switch..starts sometime then not(straight shift)cant find problem ..any idea what to look for? check the compression change spark plugs and wires

...bat + post with red/bk wire on solonoid, if cranks over without staying engaged, then not relay or starter but rather in your ign switch, ford had bad problems with ign switch some years ago doing ...

...it to pump) pump. I would by pass the relay and ign switch and run a set of jumper wires to pump from battery to see if it works . If it runs your culprit is the relay ignition switch or the

...ign. relay and ign.switch Relay is behind the panel underneath the steering wheel/ dash board. Ignition switch will be more complicated just remember always pull apart from the outside in, and only ...

...relay and still nothing. Removed the starter and checked it, it's still good. Now what do I do? Power flows from Fuse 35 50A to IGN switch. Start by checking that fuse. From IGN switch to starter ...

relay that is sticking. To check the Ign. Switch, remove the covers on the steering column to gain access to the switch, unplug it and the engine should stop, when it's running. If it's just cranking,

...relay. Power flows from the IGN switch to the fan speed switch. Then from the switch to the resistor. Then to the blower motor and to ground #G206. With the key in RUN, disconnect the electrical ...

...Relay, Ignition Switch IGN-B Fuse M5-N5 50A Ignition Switch IGN-E Fuse F7-G8 10A A/C Compressor Clutch Relay LIGHTING Fuse M8-N8 40A Instrument Panel Fuse Block, Headlamp Switch LH-HDLP Fuse F1-G2 ...

...because of an internal failure. If you find the relay box, you should be able to feel the relay click when the IGN Switch is turned. If the ECU is OK, all the relevent dash lights should turn