...idle turn the "L" screw in to make it run faster and out to slow it down. With the saw running full throttle do the same with the "H" screw. If you have to turn either more than a half turn there is ...
...Idle Screw (Not Idle Air) so the Engine will Stay Running if Required. >>Now Set the Idle Air (L) Mixture Screw so there is No Hesitation when Rapidly Throttling from Idle to Full Throttle. ...
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
idle screw down until the chain stops moving, it should still idle well enough not to stall. The chain should not move at idle. If you turn the idle screw down until the chain stops and it won't idle,
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...fast and not pulling trigger The idle speed screw (not the idle jet screw) is set too high. Turn it CCW while running until the chain stops turning, yet the engine keeps running. Hope this
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...idle, that takes care of the L screw. Now the H screw must be adjusted while the the saw is at full throttle, turn the H screw and listen for maximum and smoothest engine speed. I sugest this be done ...
Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...screw the idle screw up till it will idle,then adjust low speed mixture screw in or out so you get the highest idle.keep lowering the idle so as you adjust the screw,it wont get it any higher in ...
Question about Gas 20 In Blade Double Reciprocating Double Sided Hedge Trimmer SHC225
...idle condition readjust that screw back to the original position and proceed to adjust the other screw with the throttle full pressed. You will be able to hear the engine lean out or when it runs too ...
Question about Gas 20 In Blade Double Reciprocating Double Sided Hedge Trimmer SHC225
...wont hit/start screw air mix screws in the out like a half turn each, one controls the high end speed and one controls the idle, do idle first and adjust just a little rich then do high speed
Question about Gas 20 In Blade Double Reciprocating Double Sided Hedge Trimmer SHC225
...to when I put starting fluid but doesn't ,friend gave it to me ,this is an echo weedeater gt-2000 233417 Idle screw should be a flat head screw right under the gas tank intake near the
Question about Gas 20 In Blade Double Reciprocating Double Sided Hedge Trimmer SHC225
...idle screw that sets the idle speed (Picture B) on the carburetor need to be screwed in to open the flap a bit more. Your carburetor may not be like either of these two carburetors but close enough. ...
Usually answered in minutes!
116 Questions
71 Questions
111 Questions
76 Questions
19 Questions