Questions & Answers for: RTO idle

2003 Yamaha Kodiak starts and idles fine but as soon as I give it some gas its like the breaks are on full and it just quits but starts again and idles fine until I try to move. hey, Maybe your break ...

wont idle it will start but wont stay on wont idle Not knowing if you know anything about idle speed settings, idle mixture, etc., first check to see if all carburetor components are fully in place ...

I have a 2004 honda rancher 400cc and it won't idle. i put a can of seafoam in it and change the spark plug. It has 85 hours on the engine. It will idle if I pull the choke out a little bit clean idle

ATV 110cc idling too fast, giving no gas, it will go like you are giving it gas check the idle screww and back it out a little bit. if this doesn't change anything then check the air/fuel mixture ...

Hard start, will not idle. Have to hold throttle to keep running. Cleaned carb, did not help. When idling it is as if key was shut off. Sounds like the idle jet is clogged

...low loads. Seems to smooth out with larger load. Any suggestions? Throttle motor or control box? Idle speed screw may need adjusting slightly to increase idle speed. Also Main jet and Idle mixture ...

MY 49 CC SCOOTER WONT GO OVER 10 MPH IT BOGS DOWN BACK TO IDLE SCOOTER STARTS FINE IDLES FINE BUT BUGS DOWN WHEN I GIVE IT SOME THROTTLE No idea, it can be varible

2007 honda rancher efi idles then dies . you can flutter the throttle and it will come out of it but stall at base idle 2007 honda rancher EFI Try cleaning the spark plug with fine grit sandpaper,make

...the starter any ideas Often, it mean that the clutch stay engage. Now the question can be, is the idle to high for the clutch to disengage while at idle? you might try to reduce the idle speed by ...

High Idle when we get the 70cc ATV running Pilot jet may be t o small or your air screw isn't adjusted right try turning the air screw in all the way then turn out 1full turn test and adjust until it ...