Questions & Answers for: icm

if my icm is inside my distributor do i need to replace the whole distributor or can i replace just the icm 1993 v 6 you can just replace ICM .....thats OK. Call the dealer parts dept. and ask for the

Ad

'91 Ford Econoline - No spark still. Found no voltage from pin 2 ICM harness and consequently no voltage pulse at neg ig. coil terminal. ICM ohms tested good, ig. coil tested good. Other voltage tests

Ad

how do you remove the ignition coil Each ignition control module (ICM) has the following circuits: An ignition 1 voltage circuit A chassis ground An ignition control circuit for each cylinder A low ...

Question about 1996 Explorer

1 Answer

...STILL THERE, ANY HELP WOULD BE GREAT OK, Have you tried the following: Ignition Control Module (ICM) REMOVAL & INSTALLATION NOTE: Only the EEC-IV ignition systems use an external ICM. EEC-V ...

Question about 2003 Yukon Denali

1 Answer

what is code P1351 DTC P1351 Circuit Description The ignition control module (ICM) has independent power and ground circuits. The circuits between the ICM and the powertrain control module (PCM) ...

1993 f150 no power to icm. Shut truck off to get fuel will not restart replaced icm, coil, plugs, wires, rotor and cap. can not get power to icm. Could this be the ecm? The coil and the ICM both get ...

94 camaro wont start...no firefrom the coil has new icm , coil , fuel pump Car wont start Check the icm plug with a led testlight for pulse while the engine is cranking. Test the wire connector with ...

...cranhshaft position sensor could be the cause . Three dual tower ignition coils are mounted to the ICM, and are serviced individually. The ICM performs the following functions: • The ICM supplies a ...

12 volts at terminal A and D of the ICM plug. Has good ground and on ICM plug and led flashes when cranked when connected to whatever terminal it is on the ICM plug. 1997 Tahoe crank no spark. ...

...88 royale cranks but will not start looks like there is no power going to crank sensor from the ICM but I have power going to the ICM. I put the ICM on a different car and it works fine. Also had ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...