Questions & Answers for: ice build fan blade amana

...not heating we have amana ptacs in our hotel and they will not heat up. The fan comes on but only cold air blows out. What could the problem be? Thank you. the board or the heater need to be ...

...ice build-up on bottom of unit but fan stopped working yesterday and snow is building on the blades. Temps were single digit since Tuesday but is 26 today. It sounds like your defrost board failed. ...

Ice builds up in freezer, and vibration noise only when freezer is closed. When freezer open vibration noise stops. starts when pressing the switch which turns off the light. Replace the fan motor AND

hitting it Look closer because ice can build up and the fan just barely hits it making the noise. If the fan blades are not hitting anything, replace the fan motor as the bearings are getting worn out

...which is on the bottom. When I turn the temp dial off it stops. Model arb9058cs fan blade hitting ice or something like that. check blades to make sure not ice on them. nedd check blade

...ice build that the fan blades are hitting then the fan motor is telling you that it is about to fail, but also check the bushing on the fan motor shaft to make sure it is functional.  The part ...

...Mar 28, 2014 - Uploaded by Total Home Supply If you ever need to reset your Amana PTAC this simple guide will ... HVAC AC Blower not working, troubleshooting Fan Control board, Fan not

...will run again then only fan again..cleaned You said in another post that the error was c7. That means evaporator freeze. Too cold. That could be lack of air flow, bad sensor, ice on the

amana ptac 2012 r410a runs compressor 5-10 min then will not run only fan. freon level is good. reset and compressor will run again then only fan again..cleaned That means evaporator coil is too cold,

...Amana PTAC https://www.amana-ptac.com > products > ptac Looking to buy an energy-efficient PTAC unit for your building? Buy the new Amana R-410A PTAC unit heat pump, which reduces energy consumption ...