Questions & Answers for: ic amp

Ad

Question about PT-51HX41 51" Rear Projection Television

1 Answer

amp short out in this product? Heat or not using the right replacement IC if it keeps burning out. If it is the first time it happened, the heat sink compound dries up, and then the heat transfer goes

Ad

Question about PT-51HX41 51" Rear Projection Television

1 Answer

...vertical amp ic ,if present than change vertical amp ic.Some times supply line is dameged by faulty amp ic.therefore you have to rctify supply and replace ic.Check supply line fusible resistors. ...

Ad

Question about HX-D7 Shelf System

1 Answer

...amp ic hi, i have the same problem wiht my jvc where protection shuts of the system off with the speakers disconnected, there seemes to be no damage to the resistors or any other component around the ...

amp IC is damaged. You will probably need to replace this. Unfortunately I don't know which IC it is. I working on one right now , Auido pops in and out ,after its been on for about 5 min output dies

Question about D52W23 52" HDTV CRT TV

2 Answers

ic. model # d52w23 & where is it available .picture concaving ay top & bottom,colour out of whack. The part number for the convergence ic's are on the ic, they all start out with stk392-??? if

Question about VSX-D412 Receiver

1 Answer

...mess and it turns off You have a defective amp ic.either ic601 or ic602 will be bad you will also have an open fuseable resitor in the channel where the ic is bad. ic numbers are PAC010A AND ...

Question about VSX-D412 Receiver

2 Answers

...put secsion Transister & IC is burn.Please send this Transistor & IC number and circuit diagram this power suply. dvp 3820 dead what is ic number which is give the power supply to ...

Question about SAMTRON 55V 15" CRT Monitor

1 Answer

...When I switch on the computer The message "Controls locked i change ic dl05, &ic a41dc Are you getting message "controls locked " intermittently ? Which Ic's have you replaced ?

Question about SA-DX750 Receiver

1 Answer

...amp ic section and look at the solder connections on the amp ic's. If they have round rings around them, they are bad and need to be resoldered. This can also happens on the voltage regulators that ...

amp IC, which will be on the big heat sink? If you amp uses the latter and not individual separate devices for the power amp, suspect that over the other IC. But if the amp has separate power amps for

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76443 Answers

Cindy Wells

Level 3 Expert

6197 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Televison & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...