Questions & Answers for: Mackie ic 28

...,i have 2 SRM 450 ,they is with drivers burn WORLDWIDE DISTRIBUTORS Romania Romania - Sales & Technical Support Mackie sales and technical support in your area are managed by the distributor(s) ...

Older Cr 1604, powers up but no output, suddenly after gig. Hello, My older Cr 1604 worked great through last gig. Playing CD post gig suddenly and without warning all output stopped. Over the last ...

not that loud from the cabinet and might be more than alittle distorted. Change the audio amplifier IC If the SWA1801z Amp heats up like crazy, and he sound is not that loud from the cabinet and might

My swa1501 has no sound. The signal-lamp is constantly on, even when there's no incoming sound. Check the audio amplifier IC maybe are burned

...ic as gone on the main pcb,left chanenels are coming thru fine,and some right channels do come thru on the other sub outputs any ideas? Remember that the subs are each MONO outputs. They do not have ...

one first you check fuse no is same.if same then other part are shorted link capacitor,dioad,fet,or ic check care faully and replace with good one and same no.hope fully you found some think

what r the 5 output possibilities for the mackie 1604 On page 28 of your user manual there is a block diagram. You will find the outputs on the right side of the drawing... They will innclude the ...

...when the volume is turned off , gets louder then gose away for a short time then comes back very noticable when music off I think the fault is in the power amp section, since it's not affected by ...

Active Speaker won't power up My active speaker won't power up. There is no lights, sound, noise. I have checked the power cord and on/off switch and the fuse inside with a multimeter. ...

what is the part number of the 8pin IC in primary circuit Apart from the info needed to an accurate diagnosis mixers have been using 4560/4580 opamps since long time ago, some are SOIC or for insert ...