Questions & Answers for: Nissan iac valve

...IAC valve. However, be carefull. If your Maxima has A/T trans, than your car is set up with ECM (computer) controled engine mounts (electronic engine mounts, which move depending on engine load) to ...

...IAC valve problem. Nissan has a updated harness (with one way diode inside of the harness) to prevent backfeeding for the IAC valve and a new IAC valve also gets installed. That's where I would look. ...

...IAC) Valve When the engine (6007) is running but not at idle, the throttle valve controls the amount of air admitted into the engine. The powertrain control module (PCM) (12A650) increases the fuel ...

...an iac (idle air control) valve for a 1984 Nissan 720 2.4L pickup. Can I use an iac valve for a 1984 Maxima with a 2.4L engine instead? Yes you can ,and it will have to be adjusted ,upon

...IAC valve. That is usually behind the problem. Clean IAC valve using carb cleaner Check the parts comprised in IAC system (valve, connector, wiring, solenoid). Use the carb cleaner also to clean ...

...iac valve in the vg33e engine? The IAC valve is located under the back end of the intake plentum, drivers side. Yes you have to remove the intake plentum to gain access to it, It's held in place ...

What is the IAC valve? My van dies when cold. After it warms up it run ok. I want to know the meaning of the IAC Idle Air Control valve -used to control engines idle

...IAC valve? Do i need to reprogram the computer too cause, some were saying it might refry my IAC again.. Here's a link to your P0505 code.Here's what your iac valve looks like.It's connected to ...

IAC valve is bad , which damaged the ECM also. Have replaced couple of ECMs for this code in 2003 pathfinder. P0507 is an ICS code , which is linked to faulty IAC valve., but the ECM is an issue also,

...IAC valve--throttle motor ---throttle valve tight /sticking---ECM it also refers to idle air control (IAC) system --circuit low ===causes ---wiring short to ground ---IAC valve --ECM I would be wary ...