Questions & Answers for: Dodge iac sensor Cars & Trucks

sensor harness from the IAC Solenoid (Rear of Throttle Body) Remove the two Torx-25 Screws Remove the IAC Solenoid (Be careful not to lose the rubber O-Ring) Spray some Carb/TB Cleaner in the IAC port

...sensor? If so, where is it? Idle Air Control (IAC) Motor OPERATION The IAC motor is mounted to the throttle body and is operated by the engine controller. The throttle body has an air control passage ...

IAC is sticking it sometimes cannot compensate fast enough to avoid a stall. The problem is aggravated by the Air conditioner clutch cycling on while stopping. You don't mention the check engine light

!! Check IAC sensor and TPS and MAF sensors if IAC is ok. IAC will amke your idle go up and down all crazy and cause stalls when slowing down or releasing throttle but TPS and MAF also can effect this

...IAC) sensor/motor. This sensor/motor is located on your vehicles, throttle body and is easy to access. The purpose of this sensor is to control the car's idle under various operating conditions ...

...IAC motor mounting screws (arrows) If its running at a high idle I would test my Throttle position sensor and the idle air valve to make sure that there working properly.Next check and make sure that ...

IAC (Idle Air Control) Sensor. My Dodge did the same thing and by either cleaning the IAC or replacing the IAC did the trick. I found a video for you on Youtube on how to replace it. The IAC is on the

...sensor, TPS and IAC motor locations-typical Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment ...

idle air control valve will not close 2001 caravan just removed and cleaned the throttle body. very careful not to get sensors wet. put back together and iac stays open. The IAC valve is faulty.

...IAC sensor with code reader please? To reset the IAC (Idle Air Control) sensor on a 2004 Dodge Neon using a code reader, follow these steps: Connect the code reader to the vehicle's OBD-II port ...